in stock
john deere kits
Item condition New
Ended Apr 9, 15:59 PDT
Shipping FREE
Item location Ashmore,IL,USA
Ships to Worldwide
$380.91
60" mulching kit from John Deere, that will fit the 7-Iron & 7-Iron II decks. The mulching attachment allows converting the mower so it can be used to mulch grass or leaves. Remember you will have to follow the 1/3rd rule. No more than 1/3 of the grass blade should be cut off at one time. This allows more efficient mulching and will promote the continued good health of the grass. If the desired cut height can't be achieved by cutting off 1/3, or there is clumping of the clippings, it may be required to cut higher; wait a day, then lower the mower and make a second pass. Mow at proper intervals approximately every 4 to 5 days. This kit also includes installation instructions. This kit does not fit any other 48" decks. If you are unsure which deck you have on your mower email or call us so we can help you determine which deck you have. This 60" mulching kit is compatible on the following models with 60" 7 Iron & 7 Iron II Decks.
- 647A Commercial Quik-Trak with 60 In. 7-Iron Deck
- 647A Commercial Quik-Trak with 60 In. 7-Iron II Deck
- 717A Commercial Mini-Frame Z-TRAK with 60 In. 7-Iron II Deck
- 717E Export Region II Commercial Mini-Frame Z-TRAK with 60 In. 7-Iron Deck
- 7G18, 18 H.P. Commercial Gear Drive Walk-Behind Mower with 60 In. 7-Iron Deck
- 7H17, 17 H.P. Commercial Hydrostatic Drive Walk-Behind Mower with 60 In. 7-Iron Deck
- Z510A Z-Trak Estate Residential Zero-Turn-Radius Mower with 60 In. 7-Iron Deck
- Z915B
- Mow when grass is dry
- Observe the 1/3 rule
- No more than 1/3 of the grass blade should be cut off at one time; this allows more efficient mulching and will promote the continued good health of the grass; if the desired cut height can't be achieved by cutting off 1/3, or there is clumping of the clippings, it may be required to cut higher; wait a day, then lower the mower and make a second pass
- Mow at proper intervals�approximately every 4 to 5 days
- Always mow with sharp blades
- When using the mulch kit, clippings are held in suspension under the mower until the PTO is shut off or the engine speed is reduced to slow the mower blades; when ready to stop mulching, slowing the engine speed while continuing to drive over the cut area will allow the suspended clippings to fall and disperse more evenly over the lawn
- If mulching performance is not satisfactory, raising the mower to increase cut height, even a little bit, will often make a big difference
- If excessive clippings appear at the left edge of the mower, the left rear mower lip should be removed (if the mower is so equipped); this will promote better distribution of clippings If you have any questions about this part call us at 1-888-473-6357.
- California use info: ⚠ Warning: Cancer and Reprod
- TCB10953
- John Deere
- TCB10953
- Does Not Apply